| How to reinforce c4 |
 |
Reinforce the c4 with a wire (diameter 1 mm) and a PR band for hand tightening
(width 15.5 mm polypropylene). |
 |
Pass the wire through the two tape holes in the cassette, pass it through
the two tape holes in the adjacent cassette, and then twist the ends of
the wires with pliers at the edge of the hole to connect. |
 |
Connect the other two cassettes in the same way, and bend the twisted part
of the wire toward the hole side of the cassette to complete the reinforcement
with the wires. |
 |
Next, apply the plastic adhesive to the translucent blue part in the left photo. |
 |
Attach 3 PR bands (width 15.5mm x 36cm) for hand tightening to the part where the adhesive is applied. This completes the reinforcement with the PR band for hand tightening. |